Hi all,
I'm working on a Juniper SRX240 chassis cluster deployment and this is mostly working as intended, however, I've come across an issue with the ethernet switching.
I don't have a support contract with Juniper so I thought I would try my luck on here.
When I run the command:
show chassis cluster ethernet-switching status
I get the following output:
Ethernet switching status:
Probe state is DOWN. Both nodes are in separate ethernet switching domain(s).
This was previously reporting as UP, however, I've made so many changes since then I cannot be sure what, if any of them, may have been the cause of this - or if we're looking at hardware/fault issue.
Looking at the status for the interfaces behind it with command:
show chassis cluster ethernet-switching interfaces
I get the following output:
swfab0:
Name Status
ge-0/0/4 up
ge-0/0/7 up
swfab1:
Name Status
ge-5/0/4 up
ge-5/0/7 up
Does anyone have any experience with this functionality and could perhaps point me in the right direction to troubleshoot it?
I've had a quick look at the JunOS KB but didn't find anything that really deals with troubleshooting the set up.
No comments:
Post a Comment