I have a Sophos UTM 110/120 Firewall. This is my first time using a firewall, and I set it up from scratch with UTM 9.7 software. The installation completed and listed the Web-Interface for configuration at 192.168.0.1:4444. My modem is also at 192.168.0.1. When I try to open the page by plugging my computer directly into the LAN port, it fails to load properly, if it even connects at all. My modem is not plugged into the firewall to avoid conflict. Is there a way to change the IP address on the firewall through command line so that I can connect it to my modem without conflict and then configure it from there?
No comments:
Post a Comment