Wednesday, March 3, 2021

Best RSTP configuration for ports on the Juniper root-bridge switch

Hello Everybody,

I am not sure what is the best-recommended configuration for the ports of the root-bridge switch should I add to all ports on the core-switch(root-bridge) both commands (mode P2P and no-root-port).

Below are the commands from the Core and Access Switches:

Core(root-bridge):

set protocols rstp bridge-priority 0

set protocols rstp interface xe-2/2/7 mode point-to-point

set protocols rstp interface xe-2/2/7 no-root-port

set protocols rstp interface xe-2/3/2 mode point-to-point

set protocols rstp interface xe-2/3/2 no-root-port

Access Switch:

set protocols rstp interface ge-0/0/0 edge

set protocols rstp interface ge-0/0/1 edge

set protocols rstp interface ge-0/0/2 edge

set protocols rstp interface ge-0/0/3 edge

set protocols rstp interface ge-0/0/4 edge

set protocols rstp interface ge-0/0/5 edge

set protocols rstp interface xe-0/1/2 mode point-to-point (this is uplink to core1)

set protocols rstp interface xe-0/1/3 mode point-to-point (this is uplink to core2)

set protocols rstp bpdu-block-on-edge



No comments:

Post a Comment