I'd like to setup VRRP on a set of switches I have and they're in production. The switch IPs are currently set to .1 and .2. Do I need to change the currently configured switch IPs to enable VRRP VIP? From HP's documentation it doesn't seem like I need to, which almost seems too convenient.
Configure the router's real IP address for the current VLAN interface as the VIP for the VR instance.
virtual-ip-address ipaddr
I'm going to try it out on a test VLAN to see what it does.
Is there any good way to test this without pulling plugs?
No comments:
Post a Comment