I am trying to run a temp sensor on my work LAN. But since being located at different locations it goes through different network infrastructures. The 3rd octet changes is the only thing I notcie. Doing a test ping using two laptops before I set everything up. How do I set it up so that from one point to another I can ping each other.
Do I have to go through the routing table to tell it how to communicate by going from the central to the aft switch rack?
Do I need to build a vlan?
I’m an amateur at this but got big ideas, just not up to scratch on the know how to make it possible.
Any advice would be appreciated!
No comments:
Post a Comment