Tuesday, November 17, 2020

Cisco Aironet console commands for setting up bridge?

Have a client side / remote side AP that is already installed and trying to figure out a way to configure AP for bridge setup and also join to the WLC. I have the root AP already configured with AP Role, BGN, ethernet bridging checked, etc on the WLC but not sure how to go about configuring the mesh side? The mesh side device is currently being powered by a POE switch.  Not sure if I can set up a dhcp scope on the switch and console to it or connect to it that way.  Not sure if the AP takes dhcp by default?

Any ideas....



No comments:

Post a Comment