I have a device that requires broadcast traffic for the controller to be setup. However this device is on a different vlan than the controller software.
vlan 1 - controller vlan 2 - controller
I enabled IGMP Snooping on both vlans (Cisco SG500) Both vlans connect to an ISR 4451 through a trunk.
I assume I have to enable something on the two interfaces on the router.
I have not really done anything with Multicast Routing before so any help would be appreciated. I have found some cisco articles but I don't quite understand what this could possibly break.
Any thoughts advice would be great.
No comments:
Post a Comment