Tuesday, September 8, 2020

Cisco SDWAN Vedge in-line deployment

I am deploying a topology to simulate all possibles designs. I am struggling to configure vedge in-line, please refer to the topology. It seems that  vedge3 is not routing traffic from other routers (vedge2, on the topology). However icmp packets from the vedge(vedge3 on the topology) itself goes OK!    According to Cisco design guide we have to use a loopback interface, which I did, even though no traffic going thru.

Does anybody familiar with this kind of design?

PS:  I am not talking about tunnels at this moment, just basic connectivity between the routers.   Any help will be appreciated.   Thanks



No comments:

Post a Comment