VLan's on Nanostation M2 Wireless Bridge

This weekend, I am turning up new switches on each end of a wireless bridge.

It is configured for Bridge and Simple on the networking tab.

Device Model: NanoStation M2 Network Mode: Bridge Wireless Mode: Access Point WDS 

Is there anything special I need to do to have it support Vlan tagging? I am going to be doing a Trunk on the M2 port on each side, and have a native vlan and tagging about 8 other Vlans..

I'd hate to have an issue tomorrow morning when we remove the HP switches and put in the Cisco ones with tagging.