Hi everyone. I’m after a little help. I have a POE Camera that has stopped working. Camera tests fine straight into a switch. The CAT6 run tests fine with a Fluke Tester with the fluke termination device on one end and the fluke test unit on the other. Shows all pairs are straight though and good with a 19Ft length. But when I test the camera end of the cable with the fluke unit and the other end into the POE switch. It shows a switch connection but also a exclamation mark error (!) meaning ‘high voltage’. Any idea why it would be a good and solid cable run, but through an error when in the POE switch? I have tested multiple ports on the switch and all is good there. Any advice would be appreciated. Thanks.
No comments:
Post a Comment