Team,
Im running an FPR1010 connected to an Aris XB6 which is in bridge mode. Out of the box the config on the box is set to take the wan into the first port and do a dhcp setroute and an object nat of any, outside . I see the FPR1010 get a public ip address and traffic passes for the first few minutes and then we stop receiving any traffic from the Aris XB6. Ive changed the default AC policy to Allow all to make sure its not blocking anything at that level... I've changed the config from "No arp permit-nonconnected" to permit non-connected and still no issue so changed that back. Im wondering if this rings any bells with anyone as to what would cause the ISP to stop replying to any traffic requests after a minute or so. Ive run a Eero router in router mode behind this Arris XB6 modem before and it gets a public ip and works just fine.. So the issue must be with something on the FPR-1010. Any suggestions would be appreciated. Thanks !
No comments:
Post a Comment