Cisco WLC new SSID unable to access the internet

Hi,

I have setup new SSID but seem's like I'm not able to access the Internet or even it gateway. We are using just local and not flexconnect.

​

Question:

1. If I'm using local and not flexconnect, client traffic will be forwarded to WLC then to internet right?
2. From below comparison, Im able to ping the internet and even sourcing to personal-device interface but when I use test_263 as source I'm not able to ping the internet as well as the gateway address. (am iI using the correct command?)
3. Is there anyway I can check if the client under new SSID can access the internet from the WLC?

Checked that there no ALC added on the security tab of the WLC, IS the any thing I'm missing? Note: from ggteway which is the switch I'm able to ping the WLC new SSID interface which is 10.184.58.5.

### INTERFACE SUMMARY Interface Name Port Vlan Id IP Address Type Ap Mgr Guest guest LAG 689 192.168.0.10 Dynamic No No personal-device LAG 688 192.168.16.10 Dynamic No No test_263 LAG 263 10.184.58.5 Dynamic No No ### TESTING (WLC) >ping 8.8.8.8 Send count=3, Receive count=3 from 8.8.8.8 (WLC) >ping 8.8.8.8 test_263 Send count=3, Receive count=0 from 8.8.8.8 (adnt-ea0736ac1) >ping 10.184.58.2 test_263 Send count=3, Receive count=0 from 10.184.58.2 (WLC) >ping 8.8.8.8 personal-device Send count=3, Receive count=3 from 8.8.8.8 ### GAWTEWAY SWITCH TO NEW SSID INTERFACE #ping 10.184.58.5 Type escape sequence to abort. Sending 5, 100-byte ICMP Echos to 10.184.58.5, timeout is 2 seconds: !!!!! Success rate is 100 percent (5/5), round-trip min/avg/max = 1/4/9 ms 

Thanks