Monday, October 21, 2019

Noob Cisco Wireless Question

I just set up a Cisco 5508 WLC and a 3702 AP. The AP is in flexconnect mode. Both the link to the WLC and AP are trunks. Both are using VLAN 255 as their managment ip. Facing the AP I used "switchport trunk native vlan 255", and am able to reach it over its management ip.

My question is, how do I set up an SSID to use VLAN 100 (or any other vlan)? When I go in to my AP, under the flexconnect tab, VLAN Mappings, it shows the wlan, but says its a "Centrally switched wlan". Its grayed out to specify which vlan it is in.

edit - I think I figured it out. I had to add an additional interface to the WLC, specified for the VLAN. Then I assigned that interface to the WLAN. Seems to be working.



No comments:

Post a Comment