Hi all,
I've got an AP that i'm trying to point to my WLC using flexconnect. Not sure why but it keeps rejecting the AP name, therefore I'm unable to statically assign an IP to point to the WLC.
The AP is booting into Cisco Controller mode and expects the following syntax:
config ap primary-base <Switch Name> <Cisco AP> <Switch IP Addr>
I configure the following:
(Cisco Controller) >config ap primary-base WLC1-5520 AP123 10.122.202.1
Cisco AP name is invalid.
The AP name is EAP123, as per the below config
(Cisco Controller) >show sysinfo
Manufacturer's Name.............................. Cisco Systems Inc.
Product Name..................................... Cisco Controller
Build Info....................................... Engineering Special
Product Version.................................. 8.5.140.0
System Name...................................... EAP123
System Location..................................
System Contact...................................
System ObjectID.................................. 1.3.6.1.4.1.9.1.2370
IP Address....................................... 10.122.108.115
Last Reset....................................... 1: reload command
System Up Time................................... 0 days 0 hrs 1 mins 40 secs
System Timezone Location.........................
System Stats Realtime Interval................... 5
System Stats Normal Interval..................... 180
Configured Country............................... GB - United Kingdom
State of 802.11b Network......................... Enabled
State of 802.11a Network......................... Enabled
Number of WLANs.................................. 1
--More-- or (q)uit
Number of Active Clients......................... 0
OUI Classification Failure Count................. 0
Memory Current Usage............................. 64
Memory Average Usage............................. 64
CPU Current Usage................................ 4
CPU Average Usage................................ 12
Flash Type....................................... Compact Flash Card
Flash Size....................................... 1073741824
Burned-in MAC Address............................ removed for reddit
Maximum number of APs supported.................. 100
System Nas-Id....................................
WLC MIC Certificate Types........................ SHA1/SHA2
The AP is an AIR-2802I-Z-K9. Admittedly, this is the first time i've had to provision one of these in lieu of a AIR-2802I-E-K9. P.S cannot use CAPWAP dns or connect locally to controller. Usually this is much simpler and the syntax appears different from what I am expecting, I am assuming the software image is completely different, perhaps a capwap provisioning image?
I also tried the following:
(Cisco Controller) >config ap unifiedmode WLC1-5520 10.122.202.1
Warning! Sending config unifiedmode to all APs will cause the WLC to be rebooted.
Are you sure you want to continue? (y/n) y
Cisco AP/SWITCH name is invalid.
No comments:
Post a Comment