Hi, has anyone managed to configure static ARP entries on Dell OS10 Enterprise while also utilising VLT?
I have two switches that run VLT and a web server cluster, i am trying to add a static entry for the web server cluster MAC to the VLAN to allow routing from other subnets, however the command runs but doesnt shut in the route table.
I will run this code
config t
interface vlan 200
ip arp xx.xx.xx.xx 00:00:00:00:00:00
command takes fine, then i run a show ip arp inteface vlan 200 however the ip address / mac address is not present.
I presume its because of VLT, as this is quite a common scenario. Any help is appreciated!
No comments:
Post a Comment