I need a few bits of info if anyone can provide it. I am attempting to connect to a ngfw console port from a cisco r4300 aux port and I am unable to do so properly. When I connect im just getting ÿÿÿÿÿÿÿÿÿÿÿÿ from any input I give it.
here are my settings.
Tty Line Typ Tx/Rx A Modem Roty AccO AccI Uses Noise Overruns Int
* 1 1 AUX 115200/115200- inout - - - 116 1 0/0 -
Line 1, Location: "", Type: "xterm"
Length: 54 lines, Width: 230 columns
Baud rate (TX/RX) is 115200/115200, no parity, 1 stopbits, 8 databits
Status: Ready, Connected, Active, Modem Signals Polled
Capabilities: EXEC Suppressed, Modem Callout, Modem RI is CD
Modem state: Ready
Modem hardware state: noCTS noDSR DTR RTS
Special Chars: Escape Hold Stop Start Disconnect Activation
^^x none - - none
Timeouts: Idle EXEC Idle Session Modem Answer Session Dispatch
00:15:00 never none not set
Idle Session Disconnect Warning
never
Login-sequence User Response
00:00:30
Autoselect Initial Wait
not set
Modem type is unknown.
Session limit is not set.
Time since activation: 00:03:09
Editing is enabled.
History is enabled, history size is 10.
DNS resolution in show commands is enabled
Full user help is disabled
Allowed input transports are pad telnet rlogin ssh.
Allowed output transports are pad telnet rlogin ssh.
Preferred transport is telnet.
Shell: enabled
Shell trace: off
No output characters are padded
No special data dispatching characters
No comments:
Post a Comment