We have a hub VPN router (currently a 2901) and a 1921 on the remote side. I have to drive out and replace the 1921 with a 4431 later in the week. Probably not long after, the 1921 will be replaced with a 1002-HX.
What is the best way to enable the new router to connect to the current 2901 and the 1002-HX? We are using RSA addressed-keys. I briefly played around with using a named-key (where the name was still the IP address) in the chain, too, but I did not have much success with that. Is it possible to make a new chain containing the keys from the new hardware and to have each side reference both chains?
No comments:
Post a Comment