Device shows up as Module 1, a 5500 Series Security Services Module-20 ASA-SSM-20
HW Vs 1.0 Fw Vs 1.0(11)2 Sw vs7.1(7)E4
Module 1 Application Name IPS, Status UP
Yet...
According to the cisco guides, I should be able to
a) Create a virtual sensor using "virtual-sensor name" command
in configuration mode, I only have the option to do a virtual http hostname or ip while in enable mode virtual anything is not an option in show ?
b) After creating this virtual sensor, I should be able to do a conf t, then service analysis-engine then virtual-sensor vs1 and then set up the options from there.
No comments:
Post a Comment