I am trying to create an HSRP channel between a Cisco Catalyst 2970G and a Cisco Catalyst 3850. The port (Gi0/10) on the 2970G is shown as suspended (LEDs are amber). The port (Te1/0/14) on the 3850 is shown as not connected (though the LEDs are green).
For both the 3850 and the 2970G, I have included the output of sh vtp status, the port configuration, and the output of the interface status (sh int te1/0/14). On the 2970G, I have also included the output of sh log that reflect a VTP domain mismatch.
Cisco 3850
US04SW21(config-if)#do sh vtp status
VTP Version capable : 1 to 3
VTP version running : 1
VTP Domain Name : US04SW21
VTP Pruning Mode : Disabled
VTP Traps Generation : Enabled
Device ID : 00a2.89ac.ff00
Configuration last modified by 172.18.0.21 at 0-0-00 00:00:00
Feature VLAN:
--------------
VTP Operating Mode : Transparent
Maximum VLANs supported locally : 1005
Number of existing VLANs : 16
Configuration Revision : 0
MD5 digest : 0xC3 0xB5 0xAD 0x04 0xF4 0x5A 0x96 0xC4
0x7D 0xE0 0x0C 0x4F 0x0E 0xA5 0xBB 0x48
interface TenGigabitEthernet1/0/14
switchport mode trunk
speed 1000
duplex full
channel-group 1 mode active
end
US04SW21(config)#do sh int te1/0/14
TenGigabitEthernet1/0/14 is down, line protocol is down (notconnect)
Hardware is Ten Gigabit Ethernet, address is 00a2.89ac.ff0e (bia 00a2.89ac.ff0e)
MTU 1500 bytes, BW 10000000 Kbit/sec, DLY 10 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive not set
Full-duplex, 1000Mb/s, link type is auto, media type is unknown
input flow-control is off, output flow-control is unsupported
ARP type: ARPA, ARP Timeout 04:00:00
Last input never, output never, output hang never
Last clearing of "show interface" counters never
Input queue: 0/2000/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts (0 multicasts)
0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog, 0 multicast, 0 pause input
0 input packets with dribble condition detected
0 packets output, 0 bytes, 0 underruns
0 output errors, 0 collisions, 5 interface resets
0 unknown protocol drops
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier, 0 pause output
0 output buffer failures, 0 output buffers swapped out
Cisco Catalyst 2970G
rlmdcswitch2#sh vtp status
VTP Version : 2
Configuration Revision : 0
Maximum VLANs supported locally : 1005
Number of existing VLANs : 12
VTP Operating Mode : Transparent
VTP Domain Name : RLMDCSWITCH2
VTP Pruning Mode : Disabled
VTP V2 Mode : Disabled
VTP Traps Generation : Enabled
MD5 digest : 0x97 0x4A 0x5D 0x4D 0xCE 0x5A 0xD8 0x87
Configuration last modified by 0.0.0.0 at 0-0-00 00:00:00
interface GigabitEthernet0/10
switchport trunk encapsulation dot1q
switchport mode trunk
duplex full
speed 1000
channel-group 1 mode active
end
GigabitEthernet0/10 is up, line protocol is down (suspended)
Hardware is Gigabit Ethernet, address is 0018.736f.f90a (bia 0018.736f.f90a)
MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full-duplex, 1000Mb/s, media type is 10/100/1000BaseTX
input flow-control is off, output flow-control is unsupported
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:00:00, output 00:00:13, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
41435 packets input, 3311470 bytes, 0 no buffer
Received 41435 broadcasts (0 multicast)
0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog, 41400 multicast, 0 pause input
0 input packets with dribble condition detected
446306 packets output, 31636314 bytes, 0 underruns
0 output errors, 0 collisions, 9 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier, 0 PAUSE output
0 output buffer failures, 0 output buffers swapped out
Syslog logging: enabled (0 messages dropped, 2 messages rate-limited, 0 flushes, 0 overruns, xml disabled, filtering disabled)
Console logging: disabled
Monitor logging: disabled
Buffer logging: level debugging, 126 messages logged, xml disabled,
filtering disabled
Exception Logging: size (4096 bytes)
Count and timestamp logging messages: disabled
File logging: disabled
Trap logging: level informational, 129 message lines logged
Logging to 172.18.4.98, 129 message lines logged, xml disabled,
filtering disabled
Log Buffer (4096 bytes):
000093: *Mar 1 19:04:29.487 UTC: %LINK-3-UPDOWN: Interface GigabitEthernet0/11, changed state to up
000094: *Mar 1 19:04:37.808 UTC: %LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet0/10, changed state to up
000095: *Mar 1 19:04:40.023 UTC: %LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet0/11, changed state to up
000096: *Mar 1 19:04:55.189 UTC: %DTP-5-DOMAINMISMATCH: Unable to perform trunk negotiation on port Gi0/10 because of VTP domain mismatch.
000097: *Mar 1 19:04:58.083 UTC: %DTP-5-DOMAINMISMATCH: Unable to perform trunk negotiation on port Gi0/11 because of VTP domain mismatch.
000098: *Mar 1 19:05:07.823 UTC: %LINEPROTO-5-UPDOWN: Line protocol on Interface Vlan1, changed state to up
000099: *Mar 1 19:05:49.120 UTC: %LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet0/11, changed state to down
000100: *Mar 1 19:05:50.151 UTC: %LINK-3-UPDOWN: Interface GigabitEthernet0/11, changed state to down
000101: *Mar 1 19:05:51.133 UTC: %LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet0/10, changed state to down
000102: *Mar 1 19:05:51.150 UTC: %LINEPROTO-5-UPDOWN: Line protocol on Interface Vlan1, changed state to down
000103: *Mar 1 19:05:52.156 UTC: %LINK-3-UPDOWN: Interface GigabitEthernet0/10, changed state to down
000104: *Mar 1 19:06:20.904 UTC: %LINK-3-UPDOWN: Interface GigabitEthernet0/10, changed state to up
000105: *Mar 1 19:06:28.370 UTC: %LINK-3-UPDOWN: Interface GigabitEthernet0/11, changed state to up
000106: *Mar 1 19:06:32.740 UTC: %LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet0/10, changed state to up
000107: *Mar 1 19:06:39.619 UTC: %LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet0/11, changed state to up
000108: *Mar 1 19:06:49.660 UTC: %DTP-5-DOMAINMISMATCH: Unable to perform trunk negotiation on port Gi0/10 because of VTP domain mismatch.
000109: *Mar 1 19:06:57.009 UTC: %DTP-5-DOMAINMISMATCH: Unable to perform trunk negotiation on port Gi0/11 because of VTP domain mismatch.
000110: *Mar 1 19:07:02.755 UTC: %LINEPROTO-5-UPDOWN: Line protocol on Interface Vlan1, changed state to up
000111: *Mar 1 19:11:11.494 UTC: %PHY-4-EXCESSIVE_ERRORS: Excessive FCS, data, or idle word errors found on interface Gi0/10
000112: *Mar 1 19:24:24.091 UTC: %LINK-5-CHANGED: Interface GigabitEthernet0/10, changed state to administratively down
000113: *Mar 1 19:24:25.098 UTC: %LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet0/10, changed state to down
000114: *Mar 1 19:24:27.220 UTC: %LINEPROTO-5-UPDOWN: Line protocol on Interface Vlan1, changed state to down
000115: *Mar 1 19:24:28.202 UTC: %LINK-5-CHANGED: Interface GigabitEthernet0/11, changed state to administratively down
000116: *Mar 1 19:24:29.208 UTC: %LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet0/11, changed state to down
000117: *Mar 1 19:24:45.189 UTC: %EC-5-ERRPROT: Channel protocol mismatch for interface Gi0/10 in group 1: the interface can not be added to the channel group
000118: *Mar 1 19:25:49.622 UTC: %LINK-3-UPDOWN: Interface GigabitEthernet0/10, changed state to down
000119: *Mar 1 19:25:52.012 UTC: %LINK-3-UPDOWN: Interface GigabitEthernet0/11, changed state to down
000120: *Mar 1 19:25:52.021 UTC: %LINK-3-UPDOWN: Interface GigabitEthernet0/10, changed state to up
000121: *Mar 1 19:25:54.454 UTC: %LINK-3-UPDOWN: Interface GigabitEthernet0/11, changed state to up
000122: *Mar 1 19:26:01.584 UTC: %EC-5-L3DONTBNDL2: Gi0/10 suspended: LACP currently not enabled on the remote port.
000123: *Mar 1 19:26:04.100 UTC: %EC-5-L3DONTBNDL2: Gi0/11 suspended: LACP currently not enabled on the remote port.
000124: *Mar 1 19:26:20.685 UTC: %DTP-5-DOMAINMISMATCH: Unable to perform trunk negotiation on port Gi0/10 because of VTP domain mismatch.
000125: *Mar 1 19:26:22.983 UTC: %DTP-5-DOMAINMISMATCH: Unable to perform trunk negotiation on port Gi0/11 because of VTP domain mismatch.
000126: *Mar 1 19:28:39.206 UTC: %SYS-5-CONFIG_I: Configured from console by rlmdcswitch2 on console
From the output of sh vtp status, I see that there are different VTP versions between the switches. I also see that from the output of the log, the 3850 does not have LACP enabled.
Any assistance is greatly appreciated.
No comments:
Post a Comment