Anyone using Fiberstore's S8050 switch or really familiar with Arista EOS? (Apparently Fiberstore's FSOS was modeled after Arista EOS). I've never worked with Arista gear. I have a Fiberstore S8050 switch. The switch has four 1G/10G SFP+ ports, twenty 40G ports and four 40G/100G ports. The 10G ports are numbered 1-4. The 40G/100G ports are numbered 1-24. When looking at the switch config, there are only interfaces eth-0-1 through eth-0-24 listed. I'm trying to use the 10G ports, but either the eth-0-1 through eth-0-4 interfaces are configured to use the 40G ports or the 10G ports are just not being detected. I've tried every command I can think of that may switch the eth-0-1 through eth-0-4 interfaces over to the 10G side, but haven't had any luck. I have a ticket into Fiberstore for this, but I'm trying to get a project done quickly and this is putting a cramp in that.
Note: I have tried 1G and 10G Fiberstore branded SFPs in the 10G ports (both are listed as compatible). The transceivers are never detected by the switch. If I throw a 40G transceiver in the 1-4 QSFP slots, they are detected fine.
If anyone has any ideas, I'm all ears.
No comments:
Post a Comment