Hi here is the output of our config with a device to amazon.
I need to add 4 networks to be advertised through BGP. I am not sure if it's done through this network statement or a prefix list that's referennced. Any help would be appreciated.
router bgp 65005
bgp log-neighbor-changes
neighbor 10.2.20.102 remote-as 65005
neighbor 169.254.255.1 remote-as 7224
neighbor 169.254.255.1 timers 10 30 30
neighbor 169.254.255.5 remote-as 7224
neighbor 169.254.255.5 timers 10 30 30
!
address-family ipv4
network 0.0.0.0
network 10.0.2.0 mask 255.255.255.0
network 10.0.20.0 mask 255.255.255.0
network 10.1.0.0 mask 255.255.0.0
network 10.2.0.0 mask 255.255.0.0
network 10.2.52.0 mask 255.255.252.0
network 10.4.0.0 mask 255.255.0.0
network 10.6.0.0 mask 255.255.0.0
network 10.20.0.0 mask 255.255.0.0
network 10.23.0.0 mask 255.255.0.0
network 10.30.0.0 mask 255.255.0.0
neighbor 10.2.20.102 activate
neighbor 10.2.20.102 next-hop-self
neighbor 169.254.255.1 activate
neighbor 169.254.255.1 default-originate
neighbor 169.254.255.1 soft-reconfiguration inbound
neighbor 169.254.255.1 prefix-list aws2ccc in
neighbor 169.254.255.1 prefix-list ccc2aws out
neighbor 169.254.255.5 activate
neighbor 169.254.255.5 default-originate
neighbor 169.254.255.5 soft-reconfiguration inbound
neighbor 169.254.255.5 prefix-list aws2ccc in
neighbor 169.254.255.5 prefix-list ccc2aws out
exit-address-family
ip prefix-list ccc2aws: 11 entries
seq 10 permit 10.1.0.0/16
seq 11 permit 10.6.0.0/16
seq 12 permit 10.4.0.0/16
seq 13 permit 10.23.0.0/16
seq 14 permit 172.16.7.0/24
seq 15 permit 10.0.2.0/24
seq 17 permit 10.30.0.0/16
seq 20 permit 10.20.0.0/16
seq 25 permit 10.2.52.0/22
seq 30 permit 10.2.0.0/16
seq 35 permit 10.0.20.0/24
ip prefix-list aws2ccc: 3 entries
seq 5 permit 10.40.0.0/16
seq 10 permit 10.10.0.0/16
seq 15 permit 10.41.0.0/16
No comments:
Post a Comment