I've drawn a basic diagram here. I've cleaned it up and sanitized it a little, but aside from that, the output is a direct copy/pasta from the show ip route command on the switch, plus the route table from the Meraki.
Here's the problem: from PC1 I can ping all SVIs of the 2930f switch, but I can't ping/RDP/SSH/etc. to PC2. If I change the gateway on PC1 to 192.168.0.254 (the matching SVI on the 2930f), I can ping the gateway, but none of the other SVIs. From the switch, I can reach PC1 and PC2 via ping, telnet, and/or SSH.
I have a feeling I have something derped up in the switch. I have issued the ip routing command on the switch and we are running the latest firmware (16.05). Am I missing anything else?
There is a HPE 2530 in between the 2930f and PC2, but that one is even more vanilla. I've set an IP address on VLAN 3, a LAG to the 2930f, and credentials... Aside from that, the ports are configured as untagged vlan 3. I haven't even had a chance to configure STP yet on that switch.
This is a new deployment, so I haven't configured any ACLs on any device.
No comments:
Post a Comment