Friday, February 23, 2018

Firepower Management Center HA

I'm setting up two new 2500 FMC's. Never touched firepower before. I've got both boxes with 1 cable in eth0, connected together at layer 2. I want to setup active/standby on them, and I want to make sure I set these up in the best way. The documentation seems to just say that you setup 1 interface on both boxes with a management IP, then run through the HA wizard. Just wondering if this is literally the only cable you use to set these boxes up (i.e. one cable into both boxes)? I was expecting that you'd have a couple of ports for HA, and then maybe a seperate interface for downloading patches (like a WAN interface).



No comments:

Post a Comment