Hi,
I have a Cisco 1921 (Router A) connected to a Fortigate Firewall (Router B).
The Cisco and the Fortigate are both using GigabitEthernet and Auto Negotiation.
The Fortigate is reporting 1000Mpbs/Full (Perfect!) The Cisco is reporting 10Mbps/Half (Oh dear..)
I have tried manually setting the Cisco to 1000Mpbs/Full to match the Fortigate, however this brings the link down.
As far as I was aware a failure in auto-neg should result in Half/100Mbps and not Half/10Mbps?
Has anyone seen this before? The cable has been swapped. I am starting to suspect a faulty port.
Thanks in advance
No comments:
Post a Comment