hi, I grew up learning in cisco and mkt but I have a dell powerconnect 5424 switch installed 4 years ago that I have not touched but I need to pass a trunk interface to access mode and I have very little experience with this brand, being in config mode of the g18 interface and write the command "switchport mode access" I get the message "port g18 belongs to wrong number of vlans" what would be the steps to leave the interface in access mode and then in vlan 5?
switchport mode access
switchport access vlan 5
I leave here a capture of the cli where I was working
I would appreciate a lot if you can help me with this
No comments:
Post a Comment