Need some advice on running Fortigate 200e in transparent.
I've setup the IP and subnet 10.10.10.99 255.255.255.0 which is the same IP range as the managed switches and mikrotik router.
I've set up ipv4 as per instructions. But no luck.
If I directly connect to FG I can access the admin. But across the network I can't.
Checking mikrotik I have half a dozen vlans. All managed switches appear to be listed in there as well.
ISP router IP range is 192.168.1.0
I read within the FG manual about vlan traffic but it means very little.
Any suggestions as to where to go from here.would be appreciated.
Would it be more sensible to put it on the router IP range?
No comments:
Post a Comment