This is weird to me. I have to set my cisco router to 100/FULL and leave the Airfiber at auto. If try to let it autonegotiate, or hard code both sides, I end up with CRC errors on the cisco router.
Is there anything I can see on SSH into the airfiber that would show me more details on the data port itself to see what its negotiated too? ethtool doesnt reall show me anything.
Is this a cabling issue, or something else a miss here?
AF02.v4.0.2# ifconfig air0 Link encap:Ethernet HWaddr 26:A4:3C:38:5B:04 inet6 addr: fe80::24a4:3cff:fe38:5b04/64 Scope:Link UP BROADCAST RUNNING PROMISC MULTICAST MTU:1500 Metric:1 RX packets:13706967 errors:0 dropped:0 overruns:0 frame:0 TX packets:28728593 errors:0 dropped:16111 overruns:0 carrier:0 collisions:0 txqueuelen:1000 RX bytes:2006680106 (1.8 GiB) TX bytes:2398898445 (2.2 GiB) br0 Link encap:Ethernet HWaddr 26:A4:3C:38:5B:04 inet addr:10.255.0.250 Bcast:10.255.0.255 Mask:255.255.255.248 inet6 addr: fe80::24a4:3cff:fe38:5b04/64 Scope:Link UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 RX packets:886583 errors:0 dropped:0 overruns:0 frame:0 TX packets:878323 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:0 RX bytes:62762473 (59.8 MiB) TX bytes:78246806 (74.6 MiB) eth0 Link encap:Ethernet HWaddr 24:A4:3C:38:5B:04 UP BROADCAST PROMISC MULTICAST MTU:1500 Metric:1 RX packets:0 errors:0 dropped:0 overruns:0 frame:0 TX packets:0 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:1000 RX bytes:0 (0.0 B) TX bytes:0 (0.0 B) Interrupt:33 lo Link encap:Local Loopback inet addr:127.0.0.1 Mask:255.0.0.0 UP LOOPBACK RUNNING MTU:16436 Metric:1 RX packets:7 errors:0 dropped:0 overruns:0 frame:0 TX packets:7 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:0 RX bytes:890 (890.0 B) TX bytes:890 (890.0 B) AF02.v4.0.2# ethtool br0 Settings for br0: Link detected: yes AF02.v4.0.2#
No comments:
Post a Comment