I'm trying to configure ACL's and bind to all my vlans here and I am getting fed up with the inconsistency as far as allowing my rules to go through. One minute, the ACL works fine, then just starts blocking traffic it was just allowing a little while ago.
Also, once I bind 2 or 3 ACL's to interfaces, it won't allow me to bind any more. I get a "Cannot apply - TCP/UDP port range ingress amount exceeded." This happened to me on the same exact ACL I successfully binded before without changing anything. I literally added a deny rule at the end to log anything I may have been missing and it wouldn't allow it all of a sudden. When I removed that deny rule and put it back the way it was, I get the ingress port error...but it had no problems accepting that same list 2 minutes ago!!
This is beyond bad. Has anyone else experienced similar results when dealing with these shitty switches? I tried to push for the catalyst switches but my boss wanted an easier gui to work with, so here I am, stuck trying to get these to work now.
No comments:
Post a Comment